Hair Straightener is a device that is used for hair styling since the 1890s including the levelling and fixing of hair to give it a smooth, smooth out, and smooth appearance. The process is regularly called “rebonding” in certain nations from Southeast Asia (for example Indonesia, Singapore, Malaysia and the Philippines). If done frequently, flat irons and synthetics can be harmful to hair. Excessive fixing straightening brings about split ends. However, heat protectant sprays can diminish the harm.
How to use hair straightener: a step-by-step guide for you
The first thing you should do is wash your hair with a shampoo and a mild conditioner. You can blow dry your hair after the wash, or let it dry itself.
Dry your hair with a towel and proceed to blow-dry it from the roots up to the ends while drying the hair. Comb your hair precisely and detangle it. This you must ensure before using the best straightener.
After detangling your hairs apply heat protection spray it will keep your hair safe heat damage. Do not put the heat protection spray on your roots or scalp or it may make your scalp greesy.
Make different partitions of your hairs so you can easily straightened hair on both sides.
Set the right temperature on the flat iron, depending on the hair length.
Leave about an inch from the rootsand continue straightening your hair. Set one section of hair straight at a time. Repeat procedure for section by section.
How to curl your hair with a straightener
Preparing your hair
Make sure you have washed and dry hair your hair before using a hair straightener.
Use a thin flat iron. Your straightener ought to be around 1 to 2 inches (2.5 to 5 cm) in width from the plate and have adjusted edges, or it will not shape smooth curls. A flat, paddle-style iron also will not do twists. It’ll be a lot harder to hold and wrap in the event that you have this sort of straightener and the hair will not have any desire to remain in the perfect spot.
Apply heat protectant. Applying a heat protectant spray on your hair. It will create a protective barrier between the hair and the iron so that the hair doesn’t “frizzle” and burn.
Part your hair into sections. You’ll have better twisting of hair in if you make partitions rather than attempting the whole mess at once. The thicker your hair the more partitions you’ll have to do. Tie up the hair over your ears and put it in a bun on the top of your head.
Start at the lower part of your scalp, near your ears and neck. Leave down as much hair that you can work with for your first “layer” of twists. A decent guideline is to work with 1 to 2-inch areas all at once.
When that layer is done, you’ll unclip your hair and let down another layer. Once more, cut up what you can’t twist at this moment. Continue to twist in layers.
Smaller partitions make smaller tighter twists, also more of them. If you want a look that’s closer to ringlets, keep your partition under two inches wide.
Bigger areas bring about bouncier, looser twists that look more natural. Use partitions that are wider than two crawls for large curls.
Mix it up. You don’t need to stick completely to one size or another. For example, you could do bigger twists near your face and the top of your head to make lift and volume, and more tight, more fragile twists under for help. Attempt it at least one or two different ways and see what you like best.